Restrictions Of Your Adjustable Base; Electronic System Information - Harmony Hi Lo Manuel D'assemblage Et D'utilisation

4. Remove the batteries from your remote control (option) and SMPS if your adjustable base will not be used
for a long time period to prevent damage caused by battery leakage.
5. Do not sit on the head or leg section while in the raised position. It can damage your adjustable base and
lead to shorter life expectancy.
6. Do not lift or move the base during operation. It might cause damage to your system.
7. Do not lift or move your adjustable base by grabbing its mattress platform or its wood lower frame
(option) furnished with fabric. If it is necessary to lift or move your adjustable base, please do it by
grabbing the cross bars of its metal frame.
8. Your adjustable base must be on flat ground to avoid damage to your product.
9. Use a compatible mattress for your adjustable base. A memory foam mattress or latex mattress is
recommended. Some spring mattresses or pocket spring mattresses, for example, may not suit your
adjustable base. Consult your mattress specialist to verify your mattress is compatible.
10. Use your adjustable base in compliance with the restrictions.

Restrictions of your adjustable base

1. Do not operate lift motors above the 10% duty cycle. For example, after continuous 2-minute operation 18-
minute rest is required.
2. Do not continuously or intensively operate the massage vibrators (option) above maximum 2 hours within 6
hours.
3. Weight Restrictions: the maximum weight limits on your adjustable base for Twin, Twin XL, Full and Queen
are at a maximum of 400kg/880lbs (evenly allocated across the mattress platform). This capacity includes
the mattress and occupants. The warranty of your adjustable base will be void if excessive weight of
400kg/880lbs is loaded on your adjustable base.

Electronic system information

Radio Frequency Compliance:
Radio Frequency: 2.4 MHZ.
FCC ID: PCU-JLDK.42
Your Device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired
operation.
Attention:
In compliance with FCC RF exposure requirements, there must be no change to the antenna or the device without
permission. Users may be deprived of his/her right to the device if the device exceeds the RF exposure
requirements caused by any change the antenna.
Power Ratings:
Input: AC100-240V 50/60Hz 1.5A
Output: DC29V 1.8A
Protection Class: Class II
3