Harmony Hi Lo Manuel D'assemblage Et D'utilisation page 10

STEP 4
Insert each Clevis Pin (R) through the two holes of two Support-Braces (Q) and insert each
Cotter Pin (S) through the holes of each Clevis Pin (R), as shown in the picture. Make sure that
the Four Clevis Pins (R) and the TWO Support-Braces (Q) are securely locked by the FOUR
Cotter Pins (S).
STEP 5
Scenario 1: No Leveler will be used
In this scenario, your adjustable height choices are shown in the following table.
Once your height is determined, securely tighten the Six Support Legs (F) and Two Mid-
Legs (P), with their corresponding sectional legs, onto your Adjustable Base. Leave no
gap between leg and base. The illustrations are shown in the following pictures.
Leg Height Combinations
5.0" Support Leg (F)
2.5" Sectional Leg (SL-A)
2.0" Sectional Leg (SL-B)
5.0" Support Leg (F)
2.5" Sectional Leg (SL-A)
5.0" Support Leg (F)
2.0" Sectional Leg (SL-B)
5.0" Support Leg (F)
Corresponding Mid-Leg Combinations
8
4.0" Mid-Leg (P)
2.5" Sectional Mid-Leg (SL-C)
2.0" Sectional Mid-Leg (SL-D)
4.0" Mid-Leg (P)
2.5" Sectional Mid-Leg (SL-C)
4.0" Mid-Leg (P)
2.0" Sectional Mid-Leg (SL-D)
4.0" Mid-Leg (P)