Harmony Hi Lo Manuel D'assemblage Et D'utilisation page 18

Preset Memory Position
Step 1: Click
Step 2: Adjust the Head and Foot position to a desired position by
pressing ,
Step 3: Press and hold
flashing
Step 4: Release
flashing. Then the flashing stops immediately to indicate the memory
learning has been completed successfully.
Step 5: To default
six seconds until backlight stops flashing from first flashing.
L.
Click the button to turn on the FLOOR LED LIGHT or push to turn it off. FLOOR
LED LIGHT will stay on for five minutes if the button is not clicked again.
M.
* Click the button to turn on the HEAD VIBRATOR.
* Click the button to stop the HEAD VIRBRATOR and save the intensity status
when you exit for the next activation.
* Click the button to exit WAVE mode.
N.
Click the button to adjust the INTENSITY of HEAD VIBRATOR. There are four
levels of INTENSITY.
STRONGMEDIUMWEAKNONESTRONGMEDIUM....
O.
* Click the button to turn on the FOOT VIBRATOR.
* Click the button to stop the HEAD VIRBRATOR and save the intensity status
when you exit for the next activation.
* Click the button to exit WAVE mode.
to flatten the bed.
, ,
for 3 seconds until backlight starts
and then click one of
press and hold one of them for approximate
16
, , or
before LED stops