Harmony Hi Lo Manuel D'assemblage Et D'utilisation page 15

STEP 12 (Installing Headboard)
Raise the Backrest by using Remote Control (A) and remove the Head Rail.
Take out the Wrench (J), two Bolts (M), two Washers (O) and two Nuts (N) from the accessories
box.
Refer to the following picture. Place the Headboard Bracket (H-2) on the tube of the right hand
side of your Adjustable Base. Insert the Bolt (M) with its Washer (O) through the pre-drilled
holes on the Bracket (H-2) and the tube.
Fasten the two Bolts (M) with the two Washers (O) and the two Nuts (N) with the two Washers
(O) by using the Wrench (J).
Redo this step on the left hand side of your Adjustable Base.
STEP 13 (Installing Headboard)
The Bracket (H-1) allows adjustment to meet the dimension of user's Headboard (not included).
After choosing desired pre-drilled holes on the H-1 Bracket, pass the Bolts (M) with the
Washers (O) through the holes on H-1 and H-2 Brackets. Fasten these Bolts (M), Washers (O)
and Nuts (N) by using the Wrench (J).
STEP 14
Now place your mattress on your Adjustable Base.
All the installation procedures have been completed.
13