Klarstein BEERKULES Mode D'emploi page 39

Change a new CO cartridge (no need for keg)
2
Please change the CO cartridge if cannot pour beer out when the CO
2
at "on" position and has beer in keg.
1. When turn the CO pressure knob to "-" position, to close the CO
2
2. Open the lid, loose the cartridge sheath, and take out the empty CO
Insert a new CO cartridge in the sheath, and screw the sheath tightly until you will
2
hear a "Click", which indicates that the cartridge seal has been pierced and the
CO gas can fl ow into the keg freely. Make us the bottle sheath is fi xed tightly to
2
avoid the CO leakage. Then put CO
2
3. Close the lid of the beer cooler.
4. Turn the CO pressure knob to "+" position to turn on the CO
2
ready to pour beer out.
Note: If used correctly, one CO
case of problems with the pressure regulator, refer to the "Troubleshooting" section.
WARNING
Risk of explosion! Please use the qualifi ed CO
CO cartridge information for your reference. Never use nitrogen gas
2
cartridge in the beer cooler to avoid the explosion, because of its much
higher pressure.
CAUTION
Risk of injury! New CO
that children do not play with them.
bottle sheath into the lid.
2
cartridge is suffi cient to draw over 5 litres of beer. In
2
cartridges must be stored safely. Make sure
2
16 g CO cartridge
2
pressure knob is
2
supplying.
2
cartridge.
2
supply, and it is
2
cartridge. The below
2
EN
39