Klarstein BEERKULES Mode D'emploi page 29

INSTALLATION
Setting up
1. Take out the beer cooler from its package. Place the beer cooler on a steady and
horizontal surface, and make sure the beer cooler is at least 12 cm (5 inch) away
from other appliances or wall on each side so as to allow correct ventilation on the
appliances to get better performance.
Figure 1
2. Install the tap handle connect the tap, make sure both end fi t together perfectly (see
fi gure 1).
3. Set the water drip tray into the notch provided (see fi gure 2).
4. Plug in the beer cooler.
CAUTION
Risk of electric shock! Do not connect or disconnect the electric plug
when your hands are wet. Before use it, make sure the voltage is
conformity with plug mark, and check whether the power cord is well
connected or not. If not, please don't use it, and contact costumer
service.
Handle
Faucet
Drip tray
Figure 2
EN
29