EUROM Dual-mate 2000 RC Mode D'emploi page 20

ECO mode
The ECO mode is an energy-efficient mode; the device maintains the room temperature at
23°C. This means that if the room temperature;
•
is lower than 17°C, the device will work on high heat setting.
•
is higher than 17°C and lower than 20°C, the device will work on low heat setting.
•
Is higher than 20°C, the device will activate the fan setting.
1. Press the ECO button on the control panel or remote control; the ECO indicator lights
up.
2. The indicator light turns green.
3. The LED display shows the current temperature.
4. Press the ECO button again to deactivate.
Motion mode
1. Press the motion button on the control panel
(Figure 10, pos. 3) or remote control (Figure
10, pos. 1).
2. The motion indicator switches on.
3. The device (Figure 10, pos. 4) starts rotating
from left to right in an angle of 70°.
4. Press the motion button again to deactivate.
Timer mode
1. Press the timer button on the control panel or on the remote control.
2. Use the plus or minus button to set the desired timer (from 1 to 24 hours).
3. The device automatically goes in standby mode at set timer.
Standby mode
1. Press the OFF button on the control panel (Figure 9, pos. 4) or on the remote control
(Figure 9, pos. 1).
2. The device keeps operating in fan mode for 30 seconds. The LED display will countdown
from 30 to 1.
3. After 30 seconds the device switches to standby mode.
After operation
CAUTION
Do not use the power cable to unplug or carry the device. Do not wind the
power cable too tightly or in sharp corners. Do not wrap the power cable
around the device.
20
Figure 10