CHIEF iC Serie Instructions D'installation page 11

Installation Instructions
1A
x4
2
1/4" (6.4mm)
A
T x4
3
S x4
9/16" (14.3mm)
1B
1
x 4
2
3/8" (9.5mm)
4
(S) x 4
9/16" (14.3mm)
1
x 4
3
(T) x 4
INSTALL ARM ASSEMBLY/WALL PLATE
x4
TO WALL
Wood Installation
WARNING:
strength for this component can result in serious personal
injury or damage to equipment! It is the installer's
responsibility to make sure the structure to which this
component is attached can support five times the
combined weight of all equipment. Reinforce the structure
as required before installing the component.
1. Level arm assembly/wall plate (A) and mark locations of
pilot holes.
2. Drill 1/4" (6.4mm) diameter pilot holes into wood
supports.
3. Install lag screws (S) through flat washers (T), arm
assembly/wall plate (A), into wood supports.
INSTALL ARM ASSEMBLY/WALL PLATE
TO WALL
Concrete Installation
WARNING:
strength for this component can result in serious personal
injury or damage to equipment! It is the installer's
responsibility to make sure the structure to which this
component is attached can support five times the
combined weight of all equipment. Reinforce the
structure as required before installing the component.
1. Level wall plate and mark locations of pilot holes.
2. Drill 3/8" (9.5mm) diameter holes into concrete.
3. Install anchors (D) into holes.
CAUTION:
Do not overtighten lag screws (S)!
(D) x 4
4. Install lag screws (S) through flat washers (T), wall plate,
into anchors (D).
Failure to provide adequate structural
Failure to provide adequate structural
iCLPFA3
11