Restore Factory Settings - HomeMatic HM-LC-Sw1-Pl-DN-R1 Mode D'emploi

7

Restore factory settings

The factory settings of the switch actuator can be restored manually. If
you do this, you will lose all your settings.
To restore the factory settings, please proceed as follows:
• Press and hold down the channel button (A) for at least four
seconds until the device LED (B) will slowly start flashing.
• Release the button again.
• Press and hold down the channel button (A) again for at least 4
seconds until the device LED (B) will quickly start flashing.
• Release the button again.
The device LED stops flashing.
•
• The factory settings of the device are now restored.
Restore factory settings
> 4 s
31