General Information About The Homematic System; Start-Up; Simple Operating Functions On The Device; Teaching-In - HomeMatic HM-LC-Sw1-Pl-DN-R1 Mode D'emploi

4 General information about the Homematic
system
This device is part of the Homematic home control system and works
with the bidirectional Homematic wireless protocol.
All devices are delivered in a standard configuration. The functionality
of the device can also be configured with a programming device and
software. The additional functions that can be made available in this
way and the supplementary functions provided by the Homematic sys-
tem when it is combined with other components are described in the
Homematic WebUI Manual.
All current technical documents and updates are provided in the down-
load area at www.homematic.com.
5

Start-up

5.1

Simple operating functions on the device

• Insert the wireless switch actuator into a socket.
The device is immediately ready for operation and can be taught-in to a
Homematic CCU (or to other Homematic devices).
Via the channel button (A), connected loads can be controlled (switch
on and off) with a short button press.
Before being able to use and configure your device in the Homematic
system, the switch actuator has to be taught-in first (see sec. „5.2 Tea-
ching-in" on page 25).
5.2

Teaching-in

Please read this entire section before starting the teach-in
procedure.
To integrate the switch actuator into your Homematic system and en-
able it to communicate with other Homematic devices (e.g. Homematic

General information about the Homematic system

25