3B SCIENTIFIC PHYSICS U11323 Instructions D'utilisation page 6

•
Note the "positive" and "negative" labelling of
the hose connections - connect the hoses
correctly according to the effective direction of
the pressure.
•
During the experiment, check that no elastic
expansion of the hose is occurring – this can
cause the pressure reading to be lower than
the correct value.
6. Application
Measurement of the pressure difference in the
transparent Stirling engine U10050, and analysis of
the data using 3B NETlab
7. Sample experiment
Recording operating pressures in Stirling engine
U10050 while it is in motion
Apparatus required:
TM
1 3B NETlog unit
TM
1 3B NETlab program
1 Relative pressure sensor, ±1000 hPa
1 Transparent Stirling engine
Fig. 1 Experiment set-up for recording operating pressures in Stirling engine U10050 while in motion
TM
.
U11300
U11310
U11323
U10050
•
Set up the experiment as shown in fig. 1.
•
Connect the relative pressure sensor to the 3B
TM
NETlog unit and wait for the sensor to be
detected.
•
Using a suitable length of silicone hose, make a
pressure connection between the "positive"
hose connection of the sensor box and the
hose connection of the Stirling engine.
•
Allow the engine to heat up and, after a few
minutes, set it running.
•
Open the application program (template) for
the experiment with the ±1000 hPa relative
pressure sensor on the 3B NETlab
•
Measure the pressures.
•
Evaluate the
measurements (fig. 2).
2
TM
unit.
curve resulting from the