Publicité
Les langues disponibles
Les langues disponibles
WIRING CONNECTIONS
All wiring connections must comply with local codes and the unit
must be properly grounded.
1. Make sure box connector is secure.
2. Refer to FIGURE 8. Make wiring connections.
3. Replace electrical box cover and secure with screw.
LAMP INSTALLING OR REPLACEMENT
1. Depress sides of light diffuser until tabs of diffuser disengage from
slots in hood. Remove diffuser.
2. Install (2) 40 watt maximum, Type A-15 appliance bulbs.
3. Replace diffuser in hood by depressing sides and engaging tabs in
slots in hood.
FILTER INSTALLING AND REPLACEMENT
1. For ducted operation, install the aluminum mesh filter. For non-duct
operation, install the non-ducted filter (Model RFQTC, sold separately).
2. Refer to FIGURE 9. The filter slides into channels at the back
of the hood, on either side of the fan compartment, and snaps
under the spring clips near the front of the fan compartment.
MAINTENANCE
FILTERS
IMPORTANT: The aluminum filter should be removed once monthly
and washed in hot detergent water. Rinse in clear, warm
water and shake off excess moisture before replacing.
The filter may also be cleaned in your dishwasher.
IN A NON-DUCTED INSTALLATION: Replace filter every 3-6 months
CLEANING:
The hood should be wiped off occasionally both inside and
outside using warm water, mild dish detergent and a soft cloth.
Never use scouring powders, steel wool pads or any other
abrasive cleaners which will destroy the hood's finish.
REPLACEMENT PARTS
Should replacement parts be required, please indicate hood model
number and appropriate part number. Contact your NuTone dealer
or write to NuTone at the following address:
Attn.: Parts Department
Broan-NuTone Canada, Inc.
1140 Tristar Drive
Mississauga, Ontario L5T 1H9
Telephone: 888-88Broan (27626)
as needed.
4
Publicité
