Publicité
Les langues disponibles
Les langues disponibles
PREPARATION
1. Use the dimensional drawings (Refer to FIGURES 1-3) to lay out the
range hood's mounting holes, wiring access and ductwork by marking
the cabinet bottom and drywall where applicable.
2. Make cutouts for wiring and ductwork.
3. If the hood is to be ducted, install the ductwork so that it is flush to the
range hood's mounting surface.
• Refer to FIGURE 1 if the range hood is to be installed with a
horizontal discharge.
• Refer to FIGURE 2 and FIGURE 3 if the range hood is to be
installed with a vertical discharge.
4. Run two-conductor wire (with ground) from a power source to the
hood location. Bring approximately 12" of wiring through wiring hole
in cabinet.
5. Drill four 3/32" diameter pilot holes at points where mounting holes are
marked in cabinet bottom.
6. Insert four (4) mounting screws, leaving approximately 1/4" of
thread exposed.
7. Remove and retain the mounting screws securing the 3 1/4" x 10" duct
transition to the hood.
INSTALLATION
1. Remove the necessary duct opening and wiring knockout from the
range hood.
If the range hood is to be installed as a non-ducted unit,
remove the wiring knockout only.
If the range hood is to be installed as a ducted unit, a baffle
plate is provided to close off the non-ducted vent. Install baffle plate
(Refer to FIGURE 4) by sliding into place behind grille. Use locator
bumps to orient in grille.
2. For 7" round discharge installation, refer to FIGURE 5.
Secure 7" adapter (Model K4892000, sold separately) to the top
of hood. Install 7" round damper (Model BP87, sold separately).
For 3 1/4" x 10" vertical discharge installation, refer to FIGURE 6.
Secure 3 1/4" x 10" transition (if used) to top of hood.
For 3 1/4" x 10" horizontal discharge installation, refer to FIGURE 7.
If using the supplied 3 1/4" 10" duct transition, remove the damper flap
from the transition to prevent possible venting interference. Position
transition into wall cutout.
Note: The transition does not fasten to the hood.
3. Feed the wiring through the access hold and into the electrical box.
4. Align hood's keyhole mounting slots over the four (4) partially
installed screws.
5. Making sure the duct positions over the hood's duct transition,
push the hood against the rear wall. Secure hood by tightening screws.
6. Using a long blade screwdriver, reach into the discharge opening
and make sure the damper flap operates freely (vertical discharge only).
3
Publicité
