Setting Up The Water Dispenser - Sylvania SE80092 Guide D'utilisation

Brief Button Descriptions
ON/OFF -
SET -
SILENT -
HOT -
COLD -
°C / °F -

SETTING UP THE WATER DISPENSER

IMPORTANT: Make sure the dispenser is unplugged.
Before loading the water bottle, wipe the top of the
bottle with a clean cloth and wash hands. Avoid
touching the part of the bottle that will be directly in
contact with the water dispenser.
1. Invert the bottle on top of the dispenser and place
securely on the bottle support collar
2. Press the hot and cold dispenser buttons until
water runs from both taps
3. Plug in the dispenser
4. Press the ON / OFF button to turn on the water
dispenser
5. Press the SET button once to set the hours of the
clock. The hour digits will begin flashing. Press the
HOT and COLD buttons to adjust the hour setting.
Once you have picked the right hour setting, press
the SET button to confirm this setting. NOTE – if
you do not press any button for 8 seconds, the
settings mode will be cancelled and all the settings
will revert back to their original position. Also note
that you can keep the HOT or COLD pressed to
quickly scroll through the digits.
6. Now the minute digits will begin flashing. Press the
HOT and COLD buttons to adjust the minute
setting. Once you have picked the right minute
All manuals and user guides at all-guides.com
Press to turn ON / OFF the water dispenser. When the water dispenser is turned
on, only the clock appears on the display
Press to set the time , hot or cold temperature. The sequence is as follows: hours,
minutes, hot water temperature, cold water temperature
Press to mute the audible signals, the 'Alert Display' icon in the top right corner of
the screen will disappear to indicate that the audible signals are now muted
Press to turn ON / OFF the hot water function. In OFF mode, the water dispenser
will not perform water heating function. In ON mode, the Heating indicator on the
display will turn on and show set temperature for the heating function
Press to turn ON / OFF the cold water function. In OFF mode, the water dispenser
will not perform water cooling function. In ON mode, the Cooling indicator on the
display will turn on and show set temperature for the cooling function
Press to toggle between Celsius or Fahrenheit temperature readout
setting, press the SET button to confirm this
setting.
7. Now the hot water temperature digits will begin
flashing. If you want to change temperature read-
out to Celsius or Fahrenheit, press the °C / °F
button as required. Press the HOT and
COLD buttons to adjust the temperature setting.
Once you have picked the right temperature
setting, press the SET button to confirm this
setting.
8. Now the cold water temperature digits will begin
flashing. Press the HOT and COLD buttons to
adjust the temperature setting. Once you have
picked the right temperature setting, press the
SET button to confirm this setting.
9. Next, don't press any button for 8 seconds and the
screen will return back to only displaying the time.
Now the settings are memorized. You can check
settings by pressing SET button repeatedly.
NOTE – if there is a power failure, or the water
dispenser is unplugged, the settings will be lost.
The water dispenser will revert back to factory
programmed settings.
Contact a local water bottle distributor to
purchase water bottles.
6