Cleaning And Caring For The Dispenser; Cleaning The Dispenser Cabinet; Cleaning The Condenser; Cleaning The Drip Tray And Grille - Sylvania SE80092 Guide D'utilisation

CLEANING AND CARING FOR THE DISPENSER

IMPORTANT: Turn the water dispenser off and unplug it before cleaning

Cleaning the Dispenser Cabinet

The dispenser cabinet can be washed with mild soap and
water. Rinse thoroughly with clear water.

Cleaning the Condenser

Sweep away or vacuum up dust from the condenser coils
on the back of the unit. For best results, use a brush
.

Cleaning the Drip Tray and Grille

The dispenser drip tray is not self-draining. To reduce
water spotting, the tray and its grille should be emptied,
cleaned and wiped dry regularly.

Cleaning the Water Tanks

The water dispenser tanks need to be cleaned periodically
to prevent buildup of mineral deposits that can affect water
taste and flow. To clean the water tanks:
1 Remove the water bottle
2 Drain the water tanks ( see Draining the Dispenser,
page 7)
3 Set both power switches to the OFF position
4 Mix one quart of water with either one quart of
vinegar or four ounces of citric acid crystals
5 Pour the solution in the opening at the top of the
dispenser
6 Press each dispenser button until water just begins
to flow from the tap

Draining the Dispenser

The dispenser should be drained before cleaning the tanks
and for extended periods of non-use.
1. Remove the water bottle from the dispenser.
2. Press both dispenser buttons until no more water
comes out of the taps.
3. Place a bucket beneath the drain plug. The drain
plug is located at the rear of the dispenser (see
image to the right).
4. Remove the cap from the drain plug and allow
water to drain completely. Replace the cap.
All manuals and user guides at all-guides.com
Never use commercial cleaners or abrasive powders.
specially designed for this purpose. These are usually
available at most appliance stores.
Water left in the tray may leave deposits. Remove the
deposits by adding undiluted vinegar to the tray. Soak until
the deposits disappear or become loose enough to rinse
away.
IMPORTANT: Turn the water dispenser OFF and unplug it
before draining. Allow the dispenser to cool overnight
before draining to reduce the risk of scalding
8
7 After about twenty minutes, press the dispenser
buttons until no more water comes out of the taps
and drain the hot water tank (see Draining the
Dispenser, page 7).
8 Reinstall the water bottle ( see Loading the
Dispenser, page 5)
IMPORTANT: Before use, dispense one quart of water
from each tap to make sure the cleaning solution is
completely removed.
Drain plug cap