Troubleshooting Tips - Sylvania SE80092 Guide D'utilisation

TROUBLESHOOTING TIPS

Please check the following troubleshooting tips before calling the customer service line or having the machine
repaired.
Problem
Water not hot enough or
cold enough
Water dispenser does not
work
Water dispenser leaks
from the outside
Water dispenser is noisy
The message 'ER' (as in
ERROR) appears on the
display
All manuals and user guides at all-guides.com
Possible Causes
Dispenser is unplugged and
The fuse is blown / the circuit breaker
is tripped
All the water in the water tank has
been used
Empty water bottle
Mineral deposits are clogging the
tanks
Crack or pin hole in bottle
Water Dispenser is uneven
Bottle making a gurgling noise as
water fills the tanks
Possible short circuit or sensor
failure. The location of the message
will indicate where the error is. For
example, if the message appears in
the hot water temperature section,
there is a possibility that the hot
water sensor is experiencing an issue
What To Do
Push the power plug completely into the outlet
and make sure that the applicable switches are
set to the ON position
Replace fuse or reset the circuit breaker
Wait 40 minutes for water to heat or cool
Replace with new bottle of water
See Cleaning and Caring for the Dispenser
(pages 6-7)
Replace with a new bottle of water
Make sure the water dispenser is installed on a
level floor which is strong enough to support it
when fully loaded
This is normal
Reset the water dispenser by turning it off and
leaving it unplugged for about 3 minutes. Plug
the water dispenser back in and check if the
problem persists. If the problem persists, please
call our customer service department
9