Cleaning The Water Tanks; Draining The Dispenser; Circuit Diagram - Sylvania SE80090 Guide D'utilisation

Cleaning the Water Tanks

The water dispenser tanks need to be cleaned periodically
to prevent buildup of mineral deposits that can affect water
taste and flow. To clean the water tanks:
1 Remove the water bottle
2 Drain the water tanks ( see Draining the Dispenser,
page 7)
3 Set both power switches to the OFF position
4 Mix one quart of water with either one quart of
vinegar or four ounces of citric acid crystals
5 Pour the solution in the opening at the top of the
dispenser
6 Press each dispenser button until water just begins
to flow from the tap

Draining the Dispenser

The dispenser should be drained before cleaning the tanks
and fore extended periods of non-use.
1. Remove the water bottle from the dispenser.
2. Press both dispenser buttons until no more water
comes out of the taps.
3. Place a bucket beneath the drain plug. The drain
plug is located at the rear of the dispenser (see
image to the right).
4. Remove the cap from the drain plug and allow
water to drain completely. Replace the cap.

CIRCUIT DIAGRAM

(for reference only)
7 After about twenty minutes, press the dispenser
buttons until no more water comes out of the taps
and drain the hot water tank (see Draining the
Dispenser, page 7).
8 Reinstall the water bottle ( see Loading the
Dispenser, page 5)
IMPORTANT: Before use, dispense one quart of water
from each tap to make sure the cleaning solution is
completely removed.
IMPORTANT: Set both power switches to the OFF position
and unplug the water dispenser before draining. Allow the
dispenser to cool overnight before draining to reduce the
risk of scalding
7
Drain plug cap