Loading The Dispenser; Specifications; Cleaning And Caring For The Dispenser; Cleaning The Dispenser Cabinet - Sylvania SE80070 Guide D'utilisation

LOADING THE DISPENSER

IMPORTANT: Make sure the dispenser is unplugged
with both the hot and cold power switches set to the 0
(off) position. Before loading, wipe the top of the
bottle with a clean cloth and wash hands. Avoiding
touching the part of the bottle that will be directly in
contact with the water dispenser.
1. Invert the bottle on top of the cooler and place
securely on the bottle support collar

SPECIFICATIONS

Capacity: 3 or 5 Gallon Water Bottle
Chilling Rate: Approx. 2 liters per hour
Heating Rate: Approx. 4 liters per hour
Power Consumption:

CLEANING AND CARING FOR THE DISPENSER

IMPORTANT: Set both power switches in the 0 (off) position and unplug the water dispenser before cleaning

Cleaning the Dispenser Cabinet

The dispenser cabinet can be washed with mild soap

Cleaning the Condenser

Sweep away or vacuum up dust from the condenser coils
on the back of the unit. For best results, use a brush
.

Cleaning the Drip Tray and Grille

The dispenser drip tray is not self-draining. To reduce
water spotting, the tray and its grille should be emptied,
cleaned and wiped dry regularly.

Cleaning the Water Tanks

The water dispenser tanks need to be cleaned periodically
to prevent buildup of mineral deposits that can affect water
taste and flow. To clean the water tanks:
1 Remove the water bottle
2 Drain the water tanks ( see Draining the
Dispenser)
3 Set both power switches to the 0 (off) position
4 Mix one quart of water with either one quart of
vinegar or four ounces of citric acid crystals
5 Pour the solution in the opening at the top of the
dispenser
Cooling - 100W
Heating - 420W
2. Press the hot and cold dispenser buttons until
water runs from both taps
3. Plug in the dispenser
4. Set the HOT (red) and COLD (green) power
switches to the I (on) positions
5. Allow 30 minutes for water to reach hot and cold
temperatures
Contact a local water bottle distributor to purchase
water bottles.
and water. Rinse thoroughly with clear water. Never use
commercial cleaners or abrasive scouring powders.
specially designed for this purpose. These are usually
available at most appliance stores.
Water left in the tray may leave deposits. Remove the
deposits by adding undiluted vinegar to the tray. Soak until
the deposits disappear or become loose enough to rinse
away.
6 Press each dispenser button until water just
begins to flow from the tap
7 After about twenty minutes, press the dispenser
buttons until no more water comes out of the taps
and drain the hot water tank (see Draining the
Dispenser).
8 Reinstall the water bottle ( see Loading the
Dispenser)
IMPORTANT: Before use, dispense one quart of water
from each tap to make sure the cleaning solution is
completely removed.
6