Tone Mode (Locate Mode) - VOLTCRAFT CT-20TDR Mode D'emploi

15. TONe mODe (LOCATe mODe)

TONe mode: Locate faults in LAN, telephone and coaxial cables.
An additional fitting external cable detector is required (not included).
Heed the user manual of your external cable detector at all costs.
No results can be saved in TONE mode.
Review the following display overview for locate mode before beginning locating:
TONE MODE
2
1
MUSIC:1
Ill. 4
1 Mode
2 Conductor (1 – 8) to be tested
3 Audible signal (2 signals available)
4 Audible signal control indicator
5 An additional cable detector is required for TONE mode. Contact your retailer for an appropriate
model.
a) Conducting a test
1. Turn on the cable tester and push the TONe button. Or select "4. TONE MODE" using the
navigation buttons and confirm with the TesT button.
2. Use the navigation buttons (left and right) to select the conductor (1 – 8) to be tested. Use the
navigation button (up, down) to select one of the two audible signals.
3. Use the cable detector to check the conductor (1 – 8) for continuity. An audible signal sounds if
the test is positive.
1
4
3
5
39