Tel Mode (Telephone Cable) - VOLTCRAFT CT-20TDR Mode D'emploi

c) Conducting a test
1. Turn on the cable tester and push the LAN button. Or select "1. LAN MODE" using the navigation
buttons and confirm with the TesT button.
2. Push the LAN or TesT button to begin testing. The test result can be read on the display.
See Ill. 1.
- By negative reading "FAIL": the conductors in question blink on the display.
- In case of "FAIL" with "OPEN": The distance (from the cable end) to the interrupted point.
- In case of "FAIL" with "CROSS": the conductors in question are shown blinking in their current
position.
- In case of "FAIL" with "SPLIT" or "SHORT": the conductors in question blink.
- Remote test port: In case of "PASS", the remote test port's ID is displayed (i.e. 1) and the
remote test port beeps. For a negative result, the ID is shown as "ID-?".

13. TeL mODe (TeLePHONe CAbLe)

TeL mode: Test telephone cables.
Review the following display overview for telephone mode before beginning testing:
TEL MODE
FOR 6C
123456
||||||
123456
Ill. 2
1 Mode, number of conductors
2 Conductors
3 Result: "PASS" (positive result), "FAIL" (negative result)
4 Memory slot
5 In case of "FAIL" (negative) reading: "OPEN" (open circuit), "SHORT" (short-circuited), "CROSS"
(incorrect connection, "FAIL" is not displayed)
36
1
2
3
PASS
TEL MODE
FOR 6C
123456
||||||
123456
4
MR-1
FAIL
OPEN
5