VOLTCRAFT CT-20TDR Mode D'emploi page 33

Once all memory slots are filled, the last memory slot will be filled by each new saved
reading.
Viewing test / measuring readings:
1. Select the desired test mode.
2. Push and hold the memORY button for ca. 4 seconds. Use the navigation buttons (up, down) to
select the number of conductors:
Deleting entries:
1. Select the desired test mode.
2. Push and hold the memORY button for ca. 4 seconds.
3. Push the TesT button (9) and confirm the confirmation prompt "ALL CLEAR?" with "YES" or
"NO" with the navigation buttons (left, right). Once the data is deleted, the display shows "MR-0".
e) Remote test port
The remote test port can be used in combination with the test modes. Remove the remote test port
connector (14) from the remote test port jack (12). After use and disconnecting the cable, reinsert
the remote test port connector into the jack.
Additional remote test port connectors for this product are available as equipment under the
order number 409235.
f) Adaptors/inserts
The cable tester includes various adaptors/inserts:
- Western reduction insert RJ-45/RJ-11 (23) :
- F/BNC adaptor (24)
- TAE adaptor (RJ-11-TAE) (25)
Reduction from RJ-45 to RJ-11
: F connector to BNC
: RJ-11 to TAE
33