Inserting/Replacing Batteries; Belt Clip; Tripod Holder - VOLTCRAFT CT-20TDR Mode D'emploi

7. INseRTINg/RePLACINg bATTeRIes

Do not connect the device to voltage-carrying systems/cables.
Heed this warning also when inserting and replacing batteries.
Replace the battery when the "Battery low symbol" appears/blinks on the display.
1. Loosen the screw on the battery compartment (10) using a Phillips screwdriver and remove the
battery compartment lid.
2. To replace the battery, lift it from the battery recess and carefully disconnect the battery
connection.
3. Connect the battery connection with positive and negative poles to a 9 V battery. Heed correct
polarity, connect the battery accordingly.
4. Insert the battery into the battery recess. Do not fold or pinch the cables. Replace the battery
compartment lid and tighten the screw in place.

8. beLT CLIP

Fasten the belt clip (22) to the clip fastener (21) on the back side of the cable tester using a Phillips
screwdriver and the provided screw.

9. TRIPOD HOLDeR

1. Instead of the belt clip (see "8. BELT CLIP"), fasten the included tripod holder to the device.
2. Fasten the cable tester to a fitting tripod.
31