GIA giatsu XKRB1 Manuel De L'utilisateur page 30

Operation Instruction
On/Off
Press the " " button to turn on or off the unit.
Mode Setting
In on-state, press the "
modes as the sequence shown in below:
Auto Cooling
Note:
You cannot set to a mode from the wired controller of the
indoor unit that conflicts with the master wired controller of
an indoor unit.
Temperature Setting
Press "▲" or "▼" button to increase or decrease setting
temperature in on-state of the unit. If press either of them
continuously, temperature will be changed rapidly.
Temperature setting range is 16°C~31°C (61°F-88°F).
Note:
In Auto mode, the setting temperature is un-adjustable.
Fan Speed Setting
Press " " button, fan speed of indoor unit will change as the sequence below:
Note:
● After in stallation completed, wired controller will detect the
unit type automatically. Different types may have different
ways of fan speed display, it can be divided into the 2 kinds
above.
● In dry mode, the fan speed is default to low fan speed and
can not be adjusted.
● When set the auto mode, the indoor fan speed will be changed according to the indoor
ambient temp., The fan speed strip is not displayed.
" button to switch the operation
Dry Fan Heating
6
F
FRESH-AIR DRY G-CONTROL
F
FRESH-AIR DRY G-CONTROL
FRESH-AIR