Publicité
Les langues disponibles
Les langues disponibles
Installation and Disassembly
Installation of Wired Controller
The simple installation step of wired controller is as shown on the figure, please notice below
issues:
● Pull out the 4 core twisted pair wire from the mounting hole and pass this line through the
oblong hole located at the bottom of the wired controller.
● Use M4×25 screws to fix the base plate together with installation hole of the wall.
● Insert the through signal wire in the slot on the wired controller , also lock the wired
controller panel and base plate together.
● Then use ST2.2×4.5 screw to fixed the wired controller panel and base plate together.
Wired controller installation steps:
Clips
2
1
2
Publicité
