Publicité
Les langues disponibles
Les langues disponibles
MICROFIBER PADS
1. Lay one Microfiber Pad on flat surface, with two fastener strips facing upward.
2. Align Mop Head above Microfiber Pad. Make sure Mop Head is oriented with pad as shown,
and centered as best as possible (FIGURE 3-A).
3. Press Mop Head firmly down onto Microfiber Pad. Fastener strips will adhere to pad grips on
underside of Mop Head. Microfiber Pad should now be attached and ready for use (FIGURE 3-B).
CAUTION: Use care when handling a recently used Microfiber Pad, as it may still be hot.
NOTE: Microfiber Pads are machine washable. To avoid picking up lint, washing
separately from other fabrics is recommended. Only use liquid detergent. Avoid using
any fabric softeners or bleach. Air drying is recommended; machine drying on a low
heat or air dry setting is acceptable as well.
3-A
The Mop Head and Microfiber Pads are perfect for use on these hard floor surfaces:
•
Sealed Hardwood
•
Stained Concrete
•
Sealed Laminate
IMPORTANT: Do not use on unsealed hardwood or unglazed ceramic surfaces. Surfaces
that are not properly sealed may be warped or damaged by exposure to heat and moisture.
Care should also be taken when steaming sealed hardwood floors, as prolonged exposure
to steam in a single spot may cause damage and discoloration. To avoid this, keep the
Mop Head in constant motion on these surfaces.
Steam may remove the sheen from some floors that have been treated with wax.
Extremely rough textured floors may tear or damage Microfiber Pads.
FIGURE 3
•
•
Linoleum
Marble
•
•
Ceramic
Vinyl
•
•
Granite
Tile
3-B
7
Publicité
