Publicité
Les langues disponibles
Les langues disponibles
Warning!
Wait about ten seconds after the coffee has been dispensed before removing the filter holder. To remove it, turn it
slowly from right to left so as to prevent splashes or spurts of water or coffee.
To remove the coffee residue from the filter, press the filter lock (P) forward over the edge of the filter, turn the filter holder
over and shake it gently (Fig. 13).
When the machine is in stand-by, the lamp (M) will turn on and off periodically. This shows that the boiler thermostat is trip-
ping, which serves to keep the water temperature optimum. It is a good idea to start dispensing the coffee only when this
indicator lamp is off, and this is true for both the first cup and those that follow.
Filling the water tank during use
Be sure to fill the tank before the water is completely used up.
Turn off the machine, unplug it from the socket-outlet and fill the tank up to the level marked "MAX" with cool tap water. Put
the tank on the machine, making sure it is inserted securely, and turn it back on.
If the tank is left completely dry, air may enter the circuit, preventing coffee from being dispensed. It is therefore necessary
to turn the machine off and let it cool down in order to put it back in service. Place a container underneath the filter holder
coupling seat and turn on the machine by immediately turning the knob (L) to the position ( ). Make at least one cup of
water come out of the filter holder coupling seat to put the hydraulic circuit back in service. Stop dispensing by putting the
knob (L) back in the central "STANDBY" position. At this point the machine will start to work regularly again.
HOW TO MAKE COFFEE WITH A POD
Put the pod filter (U) inside the filter holder (Q).
1 Place the pod in the filter ring (Fig. 14).
2 Push the pod towards the bottom of the filter with your fingers (Fig. 15).
3 The pod must be well centred and placed inside the filter.
4 Now it is possible to put the filter holder in its seat. Tighten the filter holder while making sure you have hooked it properly
onto the flange (Fig. 10).
5 The pod could remain stuck in the upper part of the machine after making the coffee and when removing filter holder. To
remove it, tilt the filter holder (Fig. 16) so the pod can fall onto it.
In order to always get an excellent cup of coffee, buy the pod that bears the E.S.E. compatibility mark.
If the pod is not inserted well, or if the filter holder is not tightened firmly, a few drops of water could leak from the
filter holder.
HOW TO MAKE CAPPUCCINO
Wait for the indicator lamp (M) to turn off. It indicates that the boiler has reached the right temperature for dispensing steam.
Warning!
When warming up, your appliance may release small puffs of steam from the filter holder; this is perfectly normal.
Turn the knob (L) to the steam dispensing position (
some water will come out, followed immediately by a jet of steam whose intensity will increase within a few seconds.
Put the knob (L) back in the "STANDBY" position and place the pot of milk to be whipped under the froth accessory.
Plunge the wand all the way into the pot of milk (Fig. 19) and again turn the dispensing knob (L) progressively on the steam
position (
) until you get the result you want. During these operations you may notice that the warning light (M) goes on
and off from time to time, indicating that the boiler thermostat is keeping the water required for the steam supply at the right
temperature. Put the knob (L) back on "STANDBY" to stop dispensing steam.
Dispense the steam for a few seconds after every use to free the hole of any milk residue and clean the steam pipe
with a sponge.
USEFUL TIPS FOR OBTAINING A GOOD ITALIAN ESPRESSO
The ground coffee in the filter holder has to be pressed lightly. Whether the coffee is stronger or weaker depends on the
degree the coffee is ground, the quantity put into the filter holder and the pressing. Just a few seconds are needed for the
coffee to flow down into the cups. If the dispensing time is longer, this means that the coffee is ground too fine or that the
coffee put into the filter holder has been pressed too much.
) after placing a glass underneath the steam pipe (K), Fig. 18. First
7
Publicité
