Pro-User NFC1800 Mode D'emploi page 8

CHARGING TIME:
Divide the battery capacity by the select charging rate is the approximate charging time.
Anyway the actual charging time is depending on the battery status.
9 STEP CHARGING CHARACTERISTIC:
5 MINUTE QUICK START
If the voltage of vehicle's battery is too low to start your engine, the charger can provide a
5 minute-quick-charge to start the engine.
1. Charge the battery with 12 Amp rate for 5 minutes.
2. Disconnect the charger.
3. Start the engine, if the engine fails to start, charge the battery for 5 more minutes
before attempting to crank the engine again.
Do not try to engine start a vehicle without a battery in it. You may damage the vehicle's
system. If the engine spins, but doesn't start after several starting attempts, there is a
problem with the engine of the vehicle other than its starting system. STOP cranking the
engine until the other problem has been found and corrected.
12 VOLT OUTPUT
The charger has a 12 Volt output socket on its back. The maximum output current is 12
Amp.
To use the output socket:
1. Insert the cigarette plug of the appliance into the socket.
2. Press "12V DC output" button under standby mode
3. Turn on appliance
4. Turn off the appliance and unplug it
5. Turn off 12 Volt output socket by pressing the "12V DC output" button again.
6. Turn off the charger
NOTE:
The actual output voltage is 13.0-13.5 Volt, which is same as the voltage of a cigarette
socket in vehicles when the engine is turned on. Make sure the appliance´power
consumption is less than 140W.
8