Pro-User NFC1800 Mode D'emploi page 5

CHARGING THE BATTERY (CONTROLS AND INDICATORS)
A small LED display, eight LED indicators and six push switches make up the controls and
indicators for this charger.
PUSH SWITCHES:
ON/OFF:
Press and keep 1 second, the charger is powered on, the display shows "000" (standby
mode). If this switch is pressed and kept 1 second during working, the charger will quit
from any operating modes and be powered off.
6/12/24 V SELECT:
Press to select battery voltage.
Battery Type:
Press to select battery type from WET (Standard Lead Acid Batteries), AGM (AGM and
Deep Cycle Batteries) and GEL (Gel Batteries)
2/6/12 AMP SELECT:
Switch the charge rate among 2 Amp, 6 Amp, 12 Amp and standby mode (Please see table
below for reference). The display changes after each press and the charger will start to
work with the set rate 1 second after the last press.
CHARGE RECOMMENDATION
VOLTAGE
6V
6V
6V
12V
12V
12V
24V
24V
BATTERY VOLTAGE:
Press this button in standby mode or during charging, the display shows the battery
voltage and keep 3 second.
CHARGING RATE
2A
6A
12A
2A
6A
12A
2A
6A
BATTERY CAPACITY
5Ah -
20Ah -
40Ah -
5Ah -
20Ah -
40Ah -
5Ah -
20Ah -
5
40Ah
120Ah
240Ah
40Ah
120Ah
240Ah
40Ah
120Ah