Operating Instructions Clock And Timer - GE JCBP62 Mode D'emploi

Using the clock and timer.
Not all features are on all models.
Make sure the clock is set to the
correct time of day.
The OFF pad does not affect
the timer.
To Set the Clock
The clock must be set to the correct time
of day for the automatic oven timing
functions to work properly. The time of
day cannot be changed during a delayed
cooking or a delayed self-cleaning cycle.
Touch the CLOCK pad twice.
Touch the + or – pads.
If the + or – pads are not touched within
one minute after you touch the CLOCK
pad, the display reverts to the original
To Turn Off the Clock Display
If you have several clocks in your kitchen,
you may wish to turn off the time of day
clock display on your range.
Touch the CLOCK pad once to turn
off the time of day display. Although
you will not be able to see it, the
To Set the Timer
The timer does not control oven operations.
The maximum setting on the timer is 9 hours
and 59 minutes.
Touch the TIMER pad.
Touch the + or – pads until the
amount of time you want shows in
the display. The maximum time that
can be entered in minutes is 59.
Times more than 59 minutes should
be changed to hours and minutes.
To Reset the Timer
If the display is still showing the time
remaining, you may change it by touching
the TIMER pad, then touching the + or –
pads until the time you want appears in
the display.
To Cancel the Timer
Touch the TIMER pad twice.
www.GEAppliances.ca
setting. If this happens, touch the CLOCK
pad twice and reenter the time of day.
Touch the START/ON pad until the
time of day shows in the display. This
enters the time and starts the clock.
To check the time of day when the display is
showing other information, simply touch the
CLOCK pad. The time of day shows until another
pad is touched.
clock maintains the correct time
of day.
Touch the CLOCK pad twice to recall
the clock display.
If you make a mistake, touch the TIMER pad and
begin again.
Touch the START/ON pad. The time
will start counting down, although
the display does not change until
one minute has passed.
When the timer reaches :00, the
control will beep 3 times followed by
one beep every 6 seconds until the
TIMER pad is touched.
If the remaining time is not in the display
(clock, delay start set time or cooking
time are in the display), recall the
remaining time by touching the TIMER
pad and then touching the + or – pads to
enter the new time you want.
15