GE JCBP62 Mode D'emploi page 23

How to Delay the Start of Cleaning
Make sure the clock shows the correct
time of day.
Latch the door.
Touch the CLEAN pad.
Using the + or – pads, enter the
desired clean time.
The Clean Time is normally 4 hours. You can
change the Clean Time to any time between 3
and 5 hours, depending on the amount of soil in
your oven.
Touch the START TIME pad. The
earliest delay start time you can set
will appear in the display.
Using the + or – pads, enter the
time of day you want the clean cycle
to start.
Touch the START/ON pad.
To Stop a Clean Cycle
Touch the CLEAR/OFF pad.
Wait until the oven has cooled below the
locking temperature to unlatch the door.
You will not be able to open the door
right away unless the oven has cooled
below the locking temperature.
After a Clean Cycle
You may notice some white ash in the
oven. Wipe it up with a damp cloth after
the oven cools.
If white spots remain, remove them with a soap-
filled scouring pad and rinse thoroughly with
a vinegar and water mixture.
These deposits are usually a salt
residue that cannot be removed by
the clean cycle.
If the oven is not clean after one clean
cycle, repeat the cycle.
www.GEAppliances.ca
The display will show the delay start set
time. It will not be possible to unlatch the
oven door until the temperature drops
below the lock temperature and the
LOCKED door light goes off.
When the LOCKED door light is off,
unlatch the door.
I
You cannot set the oven for cooking
until the oven is cool enough for the
door to be unlatched.
I
While the oven is self-cleaning, you
can press the CLOCK pad to display
the time of day. To return to the clean
countdown, press the COOK TIME pad.
I
Apply a small amount of vegetable oil
to a paper towel and wipe the edges of
the oven racks with the paper towel.
Do not spray with Pam ®
lubricant sprays.
or other
23