Publicité
Les langues disponibles
Les langues disponibles
10
ITEM(S) NEEDED
#18 x 4
u. Put a 1/4-20 X 2" HHC ZP Bolt (Item #18) in
each of the four drilled locations. The bolt should
pass through the Bottom Plate and the boat
deck. Make sure to secure the motor with bolts
on each side of the Bottom Plate.
v. Place a Fender Washer (Item #12) and then a
Nylock Nut (Item #16) at the end of each bolt
as shown and tightened with the 7/16" Box End
Wrench. Make sure all hardware is secure.
NOTE:
To prevent seizing of hardware, do not use
high speed installation tools. Wetting the screws
or applying an anti-seize may help prevent seizing.
11
w. Slide the Top Plate attached to the motor back
onto the Bottom Plate that was mounted to the
Bow of the boat and secure with the Lock Washer
and Tension Screw Knob. Always check the
Tension Screw Knob and tighten when needed.
NOTE:
Lock your motor
to help prevent theft.
For warranty information please visit www.minnkotamotors.com
minnkotamotors.com
Part #2374914
#12 x 4
#16 x 4
Minn Kota Consumer & Technical Service
Johnson Outdoors Marine Electronics, Inc.
PO Box 8129
Mankato, MN 56001
ECN 39002
Bottom Plate
Inboard
Bow
Top Plate
121 Power Drive
Mankato, MN 56001
Phone (800) 227-6433
Fax (800) 527-4464
HHC ZP Bolt
Boat Deck
Outboard
Fender Washer
Nylock Nut
Bottom Plate
Bow
Lock Washer
Tension
Screw Knob
A Johnson Outdoors Company
©2018 Johnson Outdoors Marine Electronics, Inc.
All rights reserved.
Rev J
03/18
Publicité
