Publicité
Les langues disponibles
Les langues disponibles
3
d. Remove the Right Sideplate.
e. Swing the Left Sideplate out and away from
the Base Extrusion. Removing the sideplates
exposes the mounting holes in the Base
Extrusion.
3d
Mounting Holes
4
ITEM(S) NEEDED
f.
Take the Quick Release Bracket Assembly (Item
#A) and remove the Tension Screw Knob and
Lock Washer. Set the Tension Screw Knob and
the Lock Washer aside to reassemble later.
g. Slide the Top Plate and the Bottom Plate
and notice the range of motion allowed in the
bracket, and the position of the bracket when it is
completely closed. The Socket Head Cap Screw
stops the motion of the brackets when closed.
Slide the plates completely apart and set the
Bottom Plate aside.
CAUTION
Watch for pinch points when sliding the top and bottom
plates of the Quick Release Bracket.
h. On the Top Plate, take note of the placement
of the single Socket Head Cap Screw already
attached to the plate. When the Top Plate is
attached to the Base Extrusion, the screw will
sit under the mount closest to the end where the
Power Cord exits the base of the Mount.
©2018 Johnson Outdoors Marine Electronics, Inc.
Right Sideplate
#A x 1
3e
Base Extrusion
Left Sideplate
4f
Quick Release Bracket Assembly
Bottom
Plate
Slide
Socket Head
Lock Washer
Cap Screw
4h
Power Cord
Socket Head
Top Plate
Screw Knob
Top Plate
Cap Screw
minnkotamotors.com | 3
Slide
Tension
Publicité
