Publicité
Les langues disponibles
Les langues disponibles
7
o. Place the mount with the Quick Release Bracket
attached as close to the center line or keel of
the boat as possible. The motor can be installed
on either the Port or Starboard side of the boat
based on personal preference. Check placement
with the motor in the stowed and deployed
positions. Review the mounting considerations at
the beginning of the installation.
p. When the motor is in the deployed position, make
sure that the Shaft is 1-1/2" out past the Gunwale
of the boat. The lower unit, when stowed and
deployed must not encounter any obstructions.
NOTE:
Make sure that the motor will not
encounter any obstructions when sliding the motor
on and off the quick release bracket. The exact
placement of the motor and quick release bracket
when mounting may vary depending on the boat,
boat deck, and which base extrusion or bracket
the quick release bracket is being mounted to. The
Ulterra motor cannot be deployed before mounting
and connecting a power source.
8
q. Mark the side edges and rear of the Bottom Plate
on the bow of the boat.
r.
Remove the Tension Screw Knob and Lock
Washer and slide the motor and Top Plate inboard
and off to remove it from the Bottom Plate.
8r
Top Plate
9
s. Reposition the Bottom Plate on the marks made
on the bow of the boat. Make sure the U Shape
on the Bottom Plate is facing inboard. Locate
the 4 mounting holes in the Bottom Plate and
mark them on the bow. It is recommended to use
all four bolts to mount the Bottom Plate. Set the
Bottom Plate aside.
t.
Drill through the deck of the boat using a 9/32"
Drill Bit on the marked locations.
©2018 Johnson Outdoors Marine Electronics, Inc.
Bottom Plate
Bow
Lock Washer
Tension
Screw Knob
7o
7p
Gunwale
8q
Outboard
Bow of
Boat
Inboard
Markings
Drilling
Locations
Inboard
U Shape
Keel
Deck of Boat
1-1/2"
Minimum
Shaft
8r
Outboard
Bottom
Plate
Bow of
Boat
Inboard
Markings
Bottom
Plate
Drilling
Locations
Outboard
minnkotamotors.com | 5
Publicité
