Publicité
Les langues disponibles
Les langues disponibles
5
ITEM(S) NEEDED
#14 x 4
i.
Take the Top Plate and turn it so the flat side
faces upwards. Align the Mounting Holes in the
Top Plate with the Mounting Holes in the Base
Extrusion that were exposed when the sideplates
were removed. Make sure that the Socket Head
Cap Screw is located on the mount closest to
the Power Cord. The appearance of your Base
Extrusion may vary depending on motor type.
j.
Use the 1/4 -20 X 7/8 Hex Head Cap Screw
(Item #14) and Nylock Nuts (item # 16) to
secure the Top Plate to the Base Extrusion. It
is recommended to use a minimum of two bolts
on each side, placing them the farthest apart
on the mount. The screws will pass from the
bottom up, through the Top Plate and then the
Base Extrusion. The Nylock Nuts are placed on
the screws on top of the Base Extrusion and
tightened with the 7/16" Box End Wrench. Make
sure all hardware is secure.
NOTE:
To prevent seizing of hardware, do not use
high speed installation tools. Wetting the screws or
applying an anti-seize may help prevent seizing.
6
k. After the Top Plate is secured to the Base
Extrusion, reassemble the Top Plate to the
Bottom Plate by sliding it in place and securing
with the Lock Washer and Tension Screw Knob.
l.
Replace the Right Sideplate.
m. Swing the Left Sideplate back into its correct
position on the Base Extrusion.
6l
n.
Replace the four sideplate screws using a #3 or
#2 Phillips screwdriver. Two of these screws will
be located on each side of the mount.
©2018 Johnson Outdoors Marine Electronics, Inc.
#16 x 4
Right Sideplate
Nylock Nuts
Power Cord
Exits Here
Mounting
Holes
Inboard
Socket Head
Cap Screw
NOTE:
If you are mounting an Ulterra to the Quick
Release Bracket, the Clipped Washer that was
previously used to install the motor to the boat, or
included in the mounting hardware that came with
the Ulterra motor should be used. Place the Clipped
Washer above the Base Extrusion, between the Base
Extrusion and the Nylock Nut. Refer to the Ulterra
Owner's Manual online at
complete details on mounting the Ulterra.
6m
Base Extrusion
Left Sideplate
6n
Base Extrusion
Outboard
Mounting Holes
Top Plate
Hex Head
Cap Screw
minnkotamotors.com
for
Sideplate Screw
minnkotamotors.com | 4
Publicité
