Télécharger Imprimer la page

Fluke EDDYTHERM 2x Mode D'emploi page 31

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 39
 Workpieces heavier than 10 kg [22 lbs] must never be installed
on the top yoke. These must be fitted over the inductive coil on
the right-hand side post.
 If a workpiece is installed on the top yoke, the swivel head must
be rotated only in the approved direction as indicated by the
sticker on the swivel head.
iv) For workpieces with an internal diameter large enough to fit over the
inductive coil, follow these steps:
› Place the workpiece over the inductive coil using appropriate
lifting equipment.
› For best performance, adjust the position of the workpiece so that
the inductive coil is in the centre.
› Remove the protective film from the bright underside of the top
yoke before the first use.
› Position the top yoke so that it completely covers the top of both
vertical supports.
max.
10 kg
max.
22 lb
max.
80 kg
max.
176 lb
11

Publicité

loading