ARTHUR MARTIN ASF5206LOW Notice D'utilisation page 16

16
Problem and alarm code
You cannot activate the appliance.
The programme does not start.
The appliance does not fill with water.
• The end indicator flashes 1 time in‐
termittently.
• The Départ indicator flashes contin‐
uously.
The appliance does not drain the wa‐
ter.
• The end indicator flashes 2 times
intermittently.
• The Départ indicator flashes contin‐
uously.
The anti-flood device is on.
• The end indicator flashes 3 times
intermittently.
• The Départ indicator flashes contin‐
uously.
The appliance stops and starts more
times during operation.
The program lasts too long.
Small leak from the appliance door.
Possible cause and solution
• Make sure that the mains plug is connected to
the mains socket.
• Make sure that there is no damaged fuse in the
fuse box.
• Make sure that the appliance door is closed.
• Press Départ.
• If the delay start is set, cancel the setting or wait
for the end of the countdown.
• The appliance has started the procedure to re‐
charge the resin inside the water softener. The
duration of the procedure is approximately 5 mi‐
nutes.
• Make sure that the water tap is open.
• Make sure that the pressure of the water supply
is not too low. For this information, contact your
local water authority.
• Make sure that the water tap is not clogged.
• Make sure that the filter in the inlet hose is not
clogged.
• Make sure that the inlet hose has no kinks or
bends.
• Make sure that the sink spigot is not clogged.
• Make sure that the drain hose has no kinks or
bends.
• Close the water tap and contact an Authorised
Service Centre.
• It is normal. It provides optimal cleaning results
and energy savings.
• If the delayed start option is set, cancel the de‐
lay setting or wait for the end of the countdown.
• The appliance is not levelled. Loosen or tighten
the adjustable feet (if applicable).
• The appliance door is not centred on the tub.
Adjust the rear foot (if applicable).