Publicité
Les langues disponibles
Les langues disponibles
• FITTING THE HOOD
3) Fitting the telescopic pins (Fig. 8):
a) When fixing the telescopic pins to a plasterboard
ceiling ensure it is reinforced as illustrated in Fig. 3
and attach using 2 Ø10mm nuts and bolts ensuring
the bolts as sleeved between the plasterboard and
the joist supports to prevent the ceiling being damaged
when the bolts are tightened up. If the ceiling is
concrete, use Ø 10 mm steel rawl bolts or anchors plugs
with external threads (Not provided). Plastic rawl plugs
must not be used.
b) Screw the nuts onto the Ø 10 mm rod exceeding the
ceiling, the welding washers upon as illustrated Fig. 4a.
c) Slide the tubes item O around the tubes with the rod
(Fig. 4b).
d) Unscrew the lock nuts (Fig 4c) and expand the rods
to the require length.
e) Place the second washers, screw the upper tubes onto
the Ø 10 mm rod exceeding the ceiling and then tighten
the upper tubes giving a quarter turn by hand. Adjust the
lenght of the rods ensuring the canopy aligns horizontally
and vertically with the cooking appliance Fig. 4e and then
tighten the lock nuts with moderation.
4)Fix the chimney bracket item D and the hood bracket item B
on the wall Fig. 5.
5) Hook and place the hood under the pins item O for hanging the
canopy to the ceiling .
Attention: 3 persons are necessary to secure this operation.
The bracket D of the chimney is not a carrying element, only
the 2 telescopic pins and the bracket B.
6) Fix the telescopic pins to the corners of the canopy with
the washer 5 holes with the 4 screws as illustrated Fig. 4f.
7) Finish by expanding the upper tubes slightly around the
rods to the bottom Fig. 4g.
8)Check the vertical and parallelism of the chimney and the
canopy. Accessories hook onto the cup screws item T can
be adjusted horizontally and vertically by turning the
adjustment screws V1 and V2.
E
EN
G
F
C
Fig. 5
Fig. 4e
B
Fig. 4a
Fig. 4b
Fig 4c
Fig. 4f.
Fig. 4g
1
5
1
Publicité
