Publicité
Les langues disponibles
Les langues disponibles
19. LIGHT BULBS
This insert must use shielded halogen lamps (120 V, 50 W, MR16 or PAR16 with GU10 base), included.
In order to prevent the risk of personal injury, do not install a lamp
identified for use only in enclosed fixtures.
1. Install the lamps by placing the bulb leads into their grooves in the socket.
2. Gently push upwards and turn clockwise until secure.
In order to prevent the risk of personal injury, the halogen lamps must
be cooled down before removing them.
To remove lamps, gently push upwards and turn counterclockwise to disengage bulb leads from their grooves.
NOTE: If need be, use a rubber dishwashing glove to add grip when removing the bulb.
20. INSTALL BAFFLE FILTERS
Remove protective plastic film covering the baffle filters before
installing them.
It is recommended to install side filters first and finish with center one(s).
NOTE: For PIK45 model, side filters are smaller than center ones.
A vertical arrow can be found on the filters border. Make sure to install the
baffle filters with the arrow pointing towards the inside of the hood insert.
See figure beside.
1
Insert upper end of baffle filter into the insert.
2
Raise lower end of baffle filter to position inside of unit and push to insert the
filter spring inside the grease rail.
3
While pushing the baffle filter, slide it under the inner front retaining piece.
Make sure the baffle filters are positioned as shown beside in order to allow the
grease to reach the grease rail easily.
21. USE AND CARE
Baffle filters and impeller(s).
The baffle filters, impeller(s) and grease rail should be cleaned frequently. Use a warm detergent solution. Baffle filters and
impeller(s) are dishwasher safe.
Remove baffle filters by pushing them towards the back of hood and rotating downward.
Clean all-metal filters in the dishwasher using a non-phosphate detergent. Discoloration of the filter may occur if using phosphate detergent
or as a result of local water conditions—but this will not affect filter performance. This discoloration is not covered by the warranty.
Stainless steel cleaning: How to maintain its "BRIGHT LOOK"
Do:
• Regularly wash with clean cloth or rag soaked with warm
water and mild soap or liquid dish detergent.
• Always clean in the direction of original polish lines.
• Always rinse well with clear water (2 or 3 times) after
cleaning. Wipe dry completely.
• You may also use a specialized household stainless steel
cleaner.
WARNING
!
WARNING
!
CAUTION
Don't:
• Do not use any steel or stainless steel wool or any other
scrapers to remove stubborn dirt.
• Do not use any harsh or abrasive cleansers.
• Do not allow dirt to accumulate.
• Do not let plaster dust or any other construction residues
reach the hood. During construction/renovation, cover the
hood to make sure no dust sticks to stainless steel surface.
- 12 -
1
HO0090
HO0126
1
2
3
HD0334
2
Publicité
