AVM FRITZ!WLAN Repeater 450E Mode D'emploi page 7

LEDs and Buttons
The LEDs show the operating status:
on
Quality of the wireless radio
signal
Power
FRITZ!WLAN Repeater 450E is
ready for operation
WLAN
Wireless LAN function enabled.
LAN
Network device connected
all
Operate the FRITZ!WLAN Repeater 450E using the WPS button:
Initiate WPS / Enable Mesh WiFi
Connect with another access point
Factory Settings
12
fl ashing
Connection to the wireless access point is
interrupted
• The FRITZ!WLAN Repeater 450E is being
started.
• Updating FRITZ!OS
• WPS in progress; flashes fast: WPS was
aborted
• Enabling Mesh WiFi
• Adopting the wireless LAN settings
Loading factory settings
Press the WPS button
1 second
6 seconds
15 seconds
Technical Specifi cations
• IEEE 802.11n, compatible with
IEEE 802.11g/b
• Up to 450 Mbit/s (gross); the user data
rate that can actually be achieved is
somewhat below the specifi ed values.
• WPA, WPA2 (802.11i)
• Ethernet: LAN port over RJ45 socket
(gigabit Ethernet, 10/100/1000 Base-T)
• Total power consumption: approx. 5 W
• WLAN: 2.4 GHz max. 100 mW
• 230 V, 50 Hz A/C
• 0 °C to +40 °C
• Dimensions: 101 mm x 76 mm x 76 mm
• Weight: approx. 120 g
• Antennas: three integrated antennas
System Requirements
• Wireless access point compliant with
IEEE 802.11b/g/n, 2.4 GHz, automatic IP
address assignment (DHCP)
• The wireless access point must support
the encryption standard WPA or WPA2.
• For expanded Mesh WiFi functions:
FRITZ!Box with FRITZ!OS version 6.90 or
higher
• For initial confi guration with WPS: WPS-
compliant wireless access point
• For initial confi guration without WPS:
computer with wireless LAN that supports
the WPA encryption standard
• For the fi rst confi guration of WLAN: If
the MAC address fi lter is active in the
wireless access point, the MAC address
of the FRITZ!WLAN Repeater must be
entered as an exception in the MAC
address fi lter.
13