AVM FRITZ!WLAN Repeater 450E Mode D'emploi page 5

Connecting the FRITZ!WLAN Repeater 450 with Wireless LAN at the Touch of a Button
Requirements (preconfi gured in and fulfi lled by a FRITZ!Box)
• Wireless access point that supports WPS with the WPA or WPA2 encryption standard
• The SSID (name of the wireless radio network) is set to "visible" in the wireless access point, and
the MAC address filter is disabled for the initial configuration.
1. Insert the FRITZ!WLAN Repeater 450E in an outlet in the vicinity of your wireless access point (for
instance, a FRITZ!Box).
2. Press the WPS button on the FRITZ!WLAN Repeater 450E until the "WLAN" LED starts to flash.
3. Within two minutes, press the button on your wireless access point that initiates WPS. For more
information, see the documentation of this device.
The FRITZ!WLAN Repeater 450E adopts the SSID (radio network name) and the network key from
your wireless access point and establishes a secure wireless connection. Once the connection
has been established,the "Power", "WLAN" and " " LEDs light up.
4. Insert the FRITZ!WLAN Repeater in an outlet located about halfway between your wireless access
point and the wireless devices to be added to the wireless network.
The FRITZ!WLAN Repeater 450E is connected with your home network by wireless LAN. Check the
settings and perform an update if necessary. Continue reading on page 10.
8
1
2
Wireless LAN
WPS WPS
Power
WLAN
LAN
4
3
9