HEIDENHAIN EIB 5000 Mode D'emploi page 47

The cross section for connecting the
protective conductor should be at least
twice the cross section of the lines for the
temperature measurement; a minimum cross
section of 2.5 mm² is required, however.
4.2.2 EIB 52xx
Figure 7: Mounting the EIB 52xx
Use two M4x16 screws to fasten the EIB 52xx
Connect the functional earth to the appropriate
M5 thread of the housing.
When mounting the cables, ensure that the
connection is tight.
HEIDENHAIN | EIB 5000 | Operating Instructions | 11/2020
M4x16 ISO4762
5 Installation
The following steps are only to be performed
by electrical specialists.
Further information:
Page 39
5.1 General information
The connections on the device are protected by dust
protection caps from contamination and damage.
NOTICE
Contamination or damage may result if the dust
protection caps are missing!
This may impair the proper functioning of the contacts
or destroy them.
Remove dust protection caps only when connecting
measuring devices or peripherals
If you remove a measuring device or peripheral, re-
attach the dust protection cap to the connection
"Personnel qualification",
47