Onkyo SBT-200 Manuel D'instructions page 8

Aiming the remote controller
■
Before using the remote controller, please remove
a plastic shield at battery holder.
To use the remote controller, point it at the
sound bar's remote control sensor, as shown
below.
5 m
Battery installation
■
This product contains a CR coin lithium battery.
1
While pushing the locking tab towards
the center of the remote controller,
slide out the battery holder.
Back of remote controller
Locking tab
2
Remove the old battery from the
battery holder, insert the new battery
and then slide the battery holder back
into the remote controller.
Precautions for battery use
Remove the battery if the sound bar will not be
used for a long period of time. This will prevent
pontential damage due to battery leakage such
as fire, injury or contamination of a surrounding
environment.
• Do not use rechargeable battery (nickel-
cadmium battery, etc.).
• Danger of explosion if battery is incorrectly
replaced.
• Use only specified batteries.
• Batteries (battery pack or batteries installed)
shall not be exposed to excessive heat such as
Plastic shield
5 m
Positive (+) side
up
sunshine, fire or the like.
• Installing the battery incorrectly may cause the
sound bar to malfunction.
Note
• Replace the battery if the operating distance
is reduced or if the operation becomes erratic.
Purchase "CR2025", coin lithium battery.
• Periodically clean the transmitter on the remote
controller and the sensor on the sound bar with
a soft cloth.
• Exposing the sensor on the sound bar to strong
light may interfere with operation. Change the
lighting or the direction of the sound bar if this
occurs.
• Keep the remote controller away from moisture,
heat, shock and vibrations.
En-8