Onkyo SBT-200 Manuel D'instructions page 4

coloured markings identifying the terminals in
your plug, proceed as follows:
The wire which is coloured blue must be
connected to the terminal which is marked with
the letter N or coloured black.
The wire which is coloured brown must be
connected to the terminal which is marked with
the letter L or coloured red.
IMPORTANT
The plug is fitted with an appropriate fuse. If the
fuse needs to be replaced, the replacement fuse
must approved by ASTA or BSI to BS1362 and
have the same ampere rating as that indicated on
the plug. Check for the ASTA mark or the BSI mark
on the body of the fuse.
If the power cord's plug is not suitable for your
socket outlets, cut it off and fit a suitable plug. Fit
a suitable fuse in the plug.
For European Models
Declaration of Conformity
We declare, under our sole
responsibility, that this product
complies with the standards:
-
Safety
-
Limits and methods of
measurement of radio
disturbance characteristics
-
Limits for harmonic current emissions
-
Limitation of voltage changes, voltage
fluctuations and flicker
-
RoHS Directive, 2011/65/EU
-
Hereby, Onkyo Corporation, declares that this
SBT-200 is in compliance with the essential
requirements and other relevant provisions of
Directive 1999/5/EC.
WEEE
http://www.onkyo.com/manual/weee/weee.pdf
En-4