CAME ZL80 Manuel D'installation page 7

Electrical connections
ESC < > ENTER
R700 R700
L-N
230 V a.c. 50-60 Hz Power supply
24V D.C. Motor
M-N
10-E1 24V a.c 25W Max. output terminal for flashing light (when
moving)
Serial communication for PC(PC40 o PC30) connection,
A-B-GND
use mod. RS235 shielded bipolar cable with software
(optional)
+ E - Encode connection (to connect the automated device
to the control board: use a type 2402C 22AWG shielded
cable)
N.C. STOP button
1-2
The data and information provided in this manual are to be considered susceptible to change at any time without warning, by CAME cancelli automatici s.p.a.
S1-GND S1-GND
(trasponder) LT001 (creeping) (trasponder) LT001 (creeping)
N.B. to make to recognize the sensors N.B. to make to recognize the sensors
to the card, needs to connect the special to the card, needs to connect the special
card of coding (R700). card of coding (R700).
TSP00 TSP00
Black Black
Red Red
Connection sensory TSP00 Connection sensory TSP00
M E M E
C A C A
2-3P N.O. partial opening button
N.O. complete opening button.
2-3
N.O. closing button
2-4
2-7 N.O.open-close contact (in steps) or open-stop-
close-stop (sequential)
24V 3W Max. opening indicator light
10-5
24V A.C accessories power supply output terminal,
10-11
max 36 W
Antenna connection
LT001 LT001
Black
Red Red
7