Q-Connect QCCB3 Mode D'emploi page 3

1 Cover
2 Punching Channel
3 Punching Handle
4 Binding Mechanism
5 Binding Handle
6 Waste tray
Setup
Fold the cover upwards. If you see the punching pins inside the
Punching Channel, push the enclosed Punching Handle
horizontally onto the punching shaft located at the right side of
the machine. If you do not see them, push the Punching Handle
vertically onto the punching shaft. Then secure the Punching
Handle with the provided screw.
punChing
With the Punching Handle in the vertical position, align sheets or
covers and insert the edge to be bound into the Punching
Channel. The lid becomes a rigid paper support when opened. You
may let the inserted sheets rest against it. Pull the Punching Handle
all the way down.
The QCCB3 can punch max. 15 sheets of 80 gsm paper at once.
Punch maximum 1 plastic covers at a time.
Move the punching Handle upwards again and remove the
punched document.
binding
Place a plastic comb with the side to be opened upwards onto the
Binding Mechanism. Pull down the Punching Handle so far that the
comb is opened enough.
Position the punched sheets vertically in the open comb. Locate
the punched holes over the open comb fingers and rotate the
sheets forward onto the comb. When all the sheets are loaded
onto the plastic comb, release the Binding Handle to its original
position to close the plastic comb completely. You can now
remove the bound booklet and enjoy your finished work.
emptying the waSte tray
Take out the waste tray from the side of the machine. For best
results, empty the tray regularly.
Storage
Close all lids and move handles to rest position.
3
general SafeguardS
Place the comb binder on a secure and stable work surface to
prevent it from falling and causing personal injury and damage to
the machine.
Use the machine only for its intended purpose.
Always test the machine with some scrap paper before punching
the final document.
When punching plastic covers, we recommend to punch the cover
with a sheet of paper on both sides.
Empty the waste tray regularly.
Lift the machine from the bottom, not from the lids or handles.
Unauthorised maintenance is not allowed.
teChniC al data
Punching capacity: 15 sheets (80gsm).
Number of punches: 21.
Binding capacity: 250 sheets.
Maximum document size: 360mm.
Maximum binding comb: 28mm.
t
W W W . Q - C O N N E C T . C O M