Sita SitaVent Notice De Montage page 8

Competent person
The competent person has the education and/or many years of experience allowing him or
her to carry out assembly correctly according to the installation situation. He or she is also
familiar with and complies with the relevant standards and guidelines concerning flat
roof drainage and roofing membranes and is able independently to recognise and
avoid dangers and installation errors.
2.4 Residual hazards
Falling
Warning!
Risk of accidents while working at height.
When work is carried out on roofs, platforms, ladders or scaffold, falls may occur if care is
not taken.
o When working at height, always wear personal protection equipment.
o Always take suitable measures to protect against falling.
o For all work, make sure there is a stable base.
o Never lean out far over ladders or parapets.
o In addition, always observe the relevant accident prevention regulations.
Spare parts
Note.
Risk of damage due to incorrect spare parts.
The use of incorrect spare parts may result in leaks and even inadequate drainage of the building,
resulting in structural overload.
o Only use spare parts which are approved by the manufacturer.
2.5 Assembly location requirements
The assembly location must meet the following requirements:
o The assembly location must be adequately cordoned off.
o The assembly location must be clean and dry.
o Use reinforcement plates to ensure that penetrations meet structural requirements.
2.6 Personal protective equipment
Always keep available and wear the protective equipment listed below.
Protective helmet
Fall protection
Hearing protection
Protective gloves
Protective clothing
Protective goggles
8