UFESA PL2410 Mode D'emploi page 20

PROBLEM
Unit fails to heat up and
steam. Power indicator
light does not illuminate.
Water runs out of the holes
in the soleplate.
White streaks come through
the holes in the soleplate.
Brown streaks come
through the holes in the
soleplate and stain the
linen.
The soleplate is dirty or
brown and may stain the
garment .The clothe sticks
in the soleplate.
There is no steam or there
is little steam.
PRODUCT DISPOSAL
This product complies with European Directive 2012/19/EU on electrical and electronic
devices, known as WEEE (Waste Electrical and Electronic Equipment), provides the legal
framework applicable in the European Union for the disposal and reuse of waste electronic
and electrical devices. Do not dispose of this product in the bin, instead going to the electrical
and electronic waste collection centre closest to your home.
20
POSSIBLE CAUSE
Unit is not plugged in.
Water has condensed in the pipes
because you are using for the first
time or you have not used it for some
time.
The soleplate is not hot enough.
The product has a build-up of scale
because the anti-calc cartridge has
not been changed regularly.
You are using chemical descaling
agents or addititves in the water for
ironing.
You are ironing at too high a
temperature.
The water tank is empty.
The soleplate is not hot enough.
SOLUTION
Plug into electrical outlet.
Press the steam trigger away from
your ironing board until the iron
produces steam.
Wait until the iron soleplate is hot
enough or increase the temperature of
the soleplate.
Change the anti-calc cartridge
Never add this type of product in the
water tank or in the steam chamber.
Adjust the temperature dial to a lower
heat setting.
Fill the water tank.
Wait until the iron soleplate is hot
enough or increase the temperature of
the soleplate.