Cleaning And Maintenance - Domo DO9139J Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 19
www.domo-elektro.be
INSTRUCTIONS FOR SORBET:
- Make sure that the machine is turned off (O) and put the plug in the outlet.
- Position the sorbet accessory as described earlier.
Position a measuring cup under the juice spout.
Turn on the on/off switch (I).
Insert the pieces of frozen vegetable and/or fruit into the opening at the top of the
cover. Push the food down into the bowl using the pusher.
CAUTION:
Do not insert fingers or other foreign objects into the opening of the cover
while the machine is in use. Use only the pusher, and not spoons, fork, sticks,
etc.
Never use the machine with an empty bowl.
If the machine becomes stuck during use, turn the on/off switch to R and hold down
the switch so that the machine turns in the opposite direction. This could remove any
obstructions. Release the switch to stop the reverse movement. If this does not work,
turn the machine off, remove the plug from the outlet and re-assemble the machine
according to the instructions. Then try to start the machine again.
When the measuring cup is full (max. 800 ml) or when all the frozen food has been
squeezed, turn the on/off switch off (O) and empty the measuring cups.
Note: If the machine overheats, it will turn off automatically. Turn the machine off
(O). Wait 10 minutes and then push the reset button to switch the machine on again.
Caution:
Never let the machine work for longer than 30 minutes at a time.
Do not touch the on/off switch with wet hands.
If the cover becomes loosened from the bowl during use, the motor of the
machine will automatically stop to prevent any hazards.
Juice that is not drunk immediately should always be stored in the refrigerator.

CLEANING AND MAINTENANCE

Remove the plug from the outlet and allow the machine too cool completely before
cleaning.
Turn the cover loose from the bowl and disassemble the rest of the parts in reverse
order of assembly.
Empty the measuring cups and clean the cover, the pusher, the sieve, the bowl, the
squeezing screw and the measuring cups under running water. Use the cleaning brush
to clean the sieve properly.
43
DO9139J

Publicité

Table des Matières
loading

Table des Matières