Beamz TRUSS P30 Mode D'emploi page 5

This trussing left our factory in perfect condition. If transport damages should be present, do not use this product and contact your specialized dealer.
Beamz trusses are used for event and production purpose. Before installing and operating a P30/P32/P33 truss, read this manual carefully and pay
attention to all provided information. Use this manual to get familiar with the products, how to properly use the truss and follow all safety regulations.
Manuals should be available at all times for all users and employees.
The warranty claim expires with damage, which is caused by neglect of the instructions. The manufacturer does not assume any liability for the damages
resulting from it.
P30/P32/P33 trusses are designed to be repeatedly assembled and disassembled in order to carry loads in temporary or permanent installations.
Depending on the application P30/P32/P33 trusses can be judged as lifting accessories or construction products. If used as lifting accessories, trusses are
subjected to the European Machine Directive 2006/42/EC. If trusses are used as construction products in a temporary or permanent construction they
are subjected to the European Construction Regulation 305/2011/EC.
It shall be noted that it is the sole responsibility of the client to check with local authorities if the legislation used by BEAMZ is acceptable in the country of
use.
The P30/P32/P33 Truss has a sticker with marked type of truss and date of production.
The P30/P32/P33 Truss should be used according to the limits specified in the structural report and the provided declarations. All other structures that
are made of truss elements need to have dedicated structural reports. The legal compliance of an construction made from different brands is the sole
responsibility of the user and has to be always certified by a structural engineer. Beamz cannot take over the responsibility for products manufactured by
other producers. Our design and certification is made in accordance to latest European standards EN-1999 and EN-1090.
P30/P32/P33 truss is not designed for lifting people in general.
Safety precaution and load reduction should be taken into account when lifting people. Temperatures below 0degrees can cause damage to the truss. In
an aggressive environment special attention is needed. Following situation should be avoided:
• Direct contact with concrete
• Direct contact with salty water
• While coating or anodizing the structure no salt water should get in contact with the material
Adequate Personal Protection Equipment is required during assembly, disassembly, maintenance and transportation of truss. Hard heads,
gloves, sound protection and safety shoes should be always used!
Do not use any damaged or malfunctioning truss.
The client has ensure that the truss systems are incorporated in a common potential equalisation system which should be connected to
the earth wire of the electrical power supply system. Grounding the truss is very important in order to avoid getting in direct contact of
people with the electrically charged suspended fixtures.
Trusses must be protected against all mechanical damages or affecting external influences like acid or any aggressive materials or temperatures. Storage
of trusses has to be done properly in order to protect all material from harming influences or situations.
It is not allowed to drop, drag or throw the truss. During transportation trusses have to be secured against any bumping, sliding or falling down. Use always
the PPE as described in "SAFETY INSTRUCTIONS".
Pay always special attention while connecting accessories with the truss like hooks and clamps that they are dedicated to the used truss type and do not
harm the truss.
Chemical removal of coatings and surface finishes shall be carried out only after consulting with the chemical manufacturer to ensure that the chemical
will not affect the mechanical properties of the aluminium. Abrasion blasting and sanding of P30/P32/P33 trusses is not allowed.