Cooke & Lewis CLSLDISHUK1 Mode D'emploi page 7

Trouble shooting
ERROR TABLE
Error Code
E1
E2
E3
E4
E5
E6
E7
PROBLEM TABLE
Problem
Dishwasher does not start
Drainage pump doesn't stop working
Noise
Dishes and cutlery not completely clean
Filters greasy and blocked
Cloudiness forms on glassware or ceramics
Rust spots form on cutlery
Soap suds remain after use
Detergent not completely used or left
in tray
Repairs should only be carried out by a qualified specialist. Improper repairs can lead to considerable equipment damage as well as
danger to the user, and the guarantee will be invalid.
To arrange a service call, please contact our customer services on one of the following Toll Free numbers, you must contact the
number in the country in which you purchased the Dishwasher.
UK 0800 324 7818
Eire 1-800 932 230
GALA13082-02_209193_s1_s4_45cm built-in dishwasher SM V31120 BX220IM V3R.indd 7
Possible Cause
Door opened during wash cycle
Water inlet malfunction
Water drainage malfunction
Temperature sensor malfunction
Water overflow or leakage
Water leakage
Heating element malfunction
Possible Causes
Fuse blown or circuit breaker on
consumer unit has tripped
Power supply is not turned on
Water pressure is low
Possible overflow
Wash sounds are normal, though items
may move during the cycle
Incorrect loading or wrong wash
cycle selected
Filter cleaning and maintenance overdue
Not all glassware and ceramics are
dishwasher saf
Not all cutlery is dishwasher safe or will
dry thoroughly
Incorrect detergent or spilt rinse aid
Some 3-in-1 tablets do not fully dissolve
during short washes or tray is blocked
by crockery
uk@kingfisherservice.com
eire@kingfisherservice.com
Check water supply
Contact Customer Service
Contact Customer Service
Contact Customer Service
Contact Customer Service
Replace or fuse or reset consumer
unit. If this issue continues there may
be an electrical fault, contact Customer
Services for advice
Check plug is correctly installed and
power is turned on
Check water is connected and turned on
Contact Customer Services
Ensure the dishwasher is loaded
correctly before starting the program
Ensure dishwasher is loaded correctly,
the spray arms are not dirty or blocked
and select the correct cycle based on
Remove and clean all filters regularly
and use a proprietary dishwasher
cleaning solution. Always follow
the manufacturer's instructions
regarding use.
Ensure delicate or non-dishwasher safe
items are washed by hand only
e
Ensure delicate or non-dishwasher safe
items are washed by hand only or dried
by hand promptly after the wash cycle
Use correct detergent and mop up spilt
rinse aid before use
Use powder rather than 3-in-1 tablets
for short washes and reload top basket
Solution
Close door
Check filters
Solution
the soiling
has finished
before use
11/11/2020 11:59